Solutions to a combined problem of excessive hydrogen sulfide in biogas and struvite scaling
Charles, W., Cord-Ruwisch, R., Ho, G., Costa, M. and Spencer, P. (2006) Solutions to a combined problem of excessive hydrogen sulfide in biogas and struvite scaling. Water Science & Technology, 53 (6). pp. 203-210.
|PDF - Authors' Version |
Download (118kB) | Preview
*Subscription may be required
The Woodman Point Wastewater Treatment Plant (WWTP) in Western Australia has experienced two seperate problems causing avoidable maintenance costs: the build-up of massive struvite (MgNH4PO4′ 6H2O) scaling downstream of the anaerobic digester and the formation of hydrogen sulfide (H2S) levels in the digester gas to levels that compromised gas engine operation and caused high operating costs on the gas scrubber. As both problems hang together with a chemical imbalance in the anaerobic digester, we decided to investigate whether both problems could be (feasibly and economically) addressed by a common solution (such as dosing of iron solutions to precipitate both sulfide and phosphate), or by using separate approaches. Laboratory results showed that, the hydrogen sulfide emission in digesters could be effectively and economically controlled by the addition of iron dosing. Slightly higher than the theoretical value of 1.5 mol of FeCl3 was required to precipitate 1 mol of dissolved sulfide inside the digester. Due to the high concentration of PO43- in the digested sludge liquor, significantly higher iron is required for struvite precipitation. Iron dosing did not appear an economic solution for struvite control via iron phosphate formation. By taking advantage of the natural tendency of struvite formation in the digester liquid, it is possible to reduce the risk of struvite precipitation in and around the sludge-dewatering centrifuge by increasing the pH to precipitate struvite out before passing through the centrifuge. However, as the Mg2+/PO43- molar ratio in digested sludge was low, by increasing the pH alone (using NAOH) the precipitation of PO43- was limited by the amount of cations (Ca2+ and Mg2+) available in the sludge. Although this would reduce struvite precipitation in the centrifuge, it could not significantly reduced PO43- recycling back to the plant. For long-term operation, maximum PO43- reduction should be the ultimate aim to minimise PO43- accumulation in the plant. Magnesium hydroxide liquid (MHL) was found to be the most cost-effective chemical to achieve this goal. It enhanced struvite precipitation from both, digested sludge and centrate to the point where more than 95% PO43- reduction in the digested sludge was achieved.
|Publication Type:||Journal Article|
|Murdoch Affiliation:||Centre for Organic Waste Management|
School of Biological Sciences and Biotechnology
|Publisher:||International Water Association Publishing|
|Copyright:||© IWA Publishing 2006.|
|Item Control Page|
Downloads per month over past year